Yate Community Forum
OpenLTE => YateBTS => Topic started by: nurwalid on March 15, 2015, 09:32:35 PM
-
Hi.
How do I know the USRP N210 has been connected with YateBTS ?
what is the command to connect ?
know. I have done
with prequirites, installing and running on the yatebts website. and network in box (i choose regexp ^001)
-
Hello Nurwalid -
I am not aware of any use of YateBTS with the Ettus N210. We support only the Nuand BladeRF radio.
Regards,
David
-
Hi Nurwalid
The USRP B210 Works with Yate without any issues,
You need to ensure you have the Uhd Software and drivers to your linux box.
When you have done that issue the command uhd_find_devices it should at that point show your usrp type and serial number
You can also issue uhd_usrp_probe it will dump firmware on the USRP and check it, and give you a responce.
then in change your ybts.conf in /usr/local/etc/yate change the line in transceciver path=./transceiver-uhd
Then launch yate if you have done everything right you will get a red light on the rx/tx port and a green light on the rx port.
Hope this helps
-
Hi Nurwalid
The USRP B210 Works with Yate without any issues,
You need to ensure you have the Uhd Software and drivers to your linux box.
When you have done that issue the command uhd_find_devices it should at that point show your usrp type and serial number
You can also issue uhd_usrp_probe it will dump firmware on the USRP and check it, and give you a responce.
then in change your ybts.conf in /usr/local/etc/yate change the line in transceciver path=./transceiver-uhd
Then launch yate if you have done everything right you will get a red light on the rx/tx port and a green light on the rx port.
Hope this helps
thank you ver mucy techguy... i will try this ...
-
No problem,
If you need any help let me know,
-
No problem,
If you need any help let me know,
hi dude.. what version of uhd for my project?
because with uhd newest version its doent work with USRP2 N210..
and i see in the openbts forum.. uhd and openbts is pairing? is it true? how about yatebts?