Messages

1

YateBTS / Re: How can I reset my settings back to default and allow my test SIMs to register

« on: January 26, 2016, 06:05:48 AM »

Hi,

Please post the error that you receive in  'Manage SIMs'  tab from your Lab Kit Gui.

2

YateBTS / Re: Help with GSM phones connecting

« on: July 18, 2014, 02:37:39 AM »

Hello,

The first error you've  described:  "Card was not found in SIM card reader... Terminating program..."  happens when the card is not inserted in the card writer.
The program waits for a card to be inserted and if in an amount of time  the card is not inserted in the card writer, then the program will be ended. When you press "Save'" button from interface , the card has to be in the writer.

The second error "RuntimeError: SW match failed ! Expected 9000 and got 9804." also happened to me when I've tried to write with the default settings,  but physically in the card writer I had another type of card. So i guess you have a different card than the default.

Insert your card in the card writer, then from interface set the proper type of card(above you are saying that pscs_scan detected a SuperSIM) from the dropdown and then press "Save" button.

If this doesn't work properly please make another manually test, but this time add  parameter "-t supersim" (or the type of card you have in the card writer) to your command  and post  the results.

Regards,
Dana

3

YateBTS / Re: Help with GSM phones connecting

« on: July 16, 2014, 06:54:01 AM »

To detect where pySIM was installed the interface uses this command:  "which pySim-prog.py".  Setting the path in the configuration file will not help because first we have to detect that pySim was installed and in your case it doesn't seem to be detected.

Please run the command by hand to see the output and post it back.

4

Features requests / Re: Pulseaudio support

« on: January 24, 2013, 10:08:58 AM »

You can read about alsachan module: http://docs.yate.ro/wiki/Alsachan.