Show Posts
1
Windows / Client does not accept a name instead of a number in dialstring for IAX
« on: July 10, 2015, 05:29:56 PM »
Hi everyone,
for SIP accounts, instead of a phone number I can enter a subscriber name known by the server into the dial string field.
For IAX accounts, however, only phone numbers are accepted. Names are blocked immediately; the yate client does not even try to contact the server.
==> Any suggestions what I have to change in order to get names accepted for IAX?
BTW, with some other software (zoiper), names are o.k. But i do very much prefer yate.
BTW2, I need to use IAX, because these calls require just a single UDP connection (combined signalling and audio).
For testing I have set up an IAX server for the moment, which everyone may try:
Use provider: -none-
Protocol: iax
Username: yatetest
Password: yatetest
Server: ats.dyn.bawue.de (standard iax port :4569)
This server answers to any dialed number or string (min length 2 chars) and plays an announcement.
Regards,
Arnold
for SIP accounts, instead of a phone number I can enter a subscriber name known by the server into the dial string field.
For IAX accounts, however, only phone numbers are accepted. Names are blocked immediately; the yate client does not even try to contact the server.
==> Any suggestions what I have to change in order to get names accepted for IAX?
BTW, with some other software (zoiper), names are o.k. But i do very much prefer yate.
BTW2, I need to use IAX, because these calls require just a single UDP connection (combined signalling and audio).
For testing I have set up an IAX server for the moment, which everyone may try:
Use provider: -none-
Protocol: iax
Username: yatetest
Password: yatetest
Server: ats.dyn.bawue.de (standard iax port :4569)
This server answers to any dialed number or string (min length 2 chars) and plays an announcement.
Regards,
Arnold