Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cornacchia

Pages: [1]
1
YateBTS / YateBTS USRP support
« on: July 20, 2018, 09:12:31 AM »
Greetings,
I have been looking around a bit now to understand if there's a way to make YateBTS work with the USRP B200 SDR.

I looked into the documentation and found this info which I think is outdated (https://wiki.yatebts.com/index.php/Running):

Quote
You will also need to modify the Path in the [transceiver] section, depending on the transceiver used. The example below shows the necessary set-up when using the bladeRF transceiver. ./transceiver is a link to ./transceiver-bladerf.

[transceiver]
;Path to the transceiver relative to where MBTS is started.
;Should be one of: ./transceiver-bladerf ./transceiver-rad1 ./transceiver-usrp1 ./transceiver-uhd.
;Defaults to ./transceiver
Path=./transceiver

I also found this old post which says something similar to the quote above: https://forum.yate.ro/index.php?topic=429.0

The file ybts.conf now says:
Quote
; In newer versions of YateBTS the transceiver is no longer an external executable.
; The "gsmtrx" Yate module implements the device independent transceiver logic and
;  uses the configuration from this section.
; The radio device is implemented in another Yate module named "ybladerf". If you
;  need to configure board specific parameters please edit ybladerf.conf

Does this mean that YateBTS is now only compatible with the BladeRF?

If not, how could I run it with a USRP SDR?

Thank you very much for your attention

Pages: [1]