General Category > Features requests
How to manually set the argument for SIP method "REGISTER"?
(1/1)
ogogon:
Dear colleagues, I have not quite typical question.
I need to manually set the argument for SIP method "REGISTER".
I use Yate for acces to multiple accounts of one large telephone operator.
Access is via a corporate network that uses the intranet address. DNS servers in it are not available.
Nevertheless, by their rules, the argument to the command "register" must be not IP-address, but the internal domain name of registration server. This is a condition of their authorization system and this issue is not discussed.
I set IP-address of the registrar, because appeal to their DNS is not possible:
--- Quote ---registrar=10.XXX.YYY.ZZZ:5060
--- End quote ---
On this basis, Yate forms the argument of the method "REGISTER":
--- Quote ---REGISTER sip:[10.XXX.YYY.ZZZ:5060] SIP/2.0
--- End quote ---
But according to the rules I need to create completely different argument.
--- Quote ---REGISTER sip:ims.intranet.telephonic.com SIP/2.0
--- End quote ---
How can I do that?
Advance grateful for the answer on the subject matter,
Ogogon.
Monica Tepelus:
Hi,
Try setting this in the /etc/hosts on the machine where yate is running:
10.XXX.YYY.ZZZ ims.intranet.telephonic.com
and in accfile.conf
registrar=ims.intranet.telephonic.com
5060 is the default port, so you don't need to specify it
marian:
Try to set registrar address in outbound parameter and registrar to required domain:
outbound=10.XXX.YYY.ZZZ:5060
registrar=ims.intranet.telephonic.com
ogogon:
--- Quote from: marian on March 04, 2016, 03:11:58 AM ---Try to set registrar address in outbound parameter and registrar to required domain:
outbound=10.XXX.YYY.ZZZ:5060
registrar=ims.intranet.telephonic.com
--- End quote ---
Thank you. Your variant has successfully registered.
Ogogon.
Navigation
[0] Message Index
Go to full version