Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Topics - ky4k0b

Pages: [1]
Other Yate server issues / yate doesn't proxy rtp between legs
« on: April 05, 2018, 10:53:33 AM »
Hi, I'm facing pretty same issue as described here

I have the following setup with yate binded to two interfaces - wan and vpn

unfortunately yate doesn't pass rtp streams between legs so it causes dead air.

regexroute is very basic - send all calls to Bob(VPN)

If you can help me that would be great. Full debug is here:

Yate users hangout place / yate basic configuration
« on: May 15, 2014, 06:13:13 PM »
Hello yate gurus!

I just installed yate pbx on debian and need to implement simple scheme with routing based on prefixes.
         GW1 (
            ↓  (no registration, auth by ip-address only)
   ↓                 ↓ (yate registers on both GW2 and GW3)
GW2           GW3

What is done so far:
Code: (accfile.conf) [Select]


I see in /var/log/yate
Code: [Select]
20140515233120.052067 <sip:CALL> SIP line 'test1' logon success to I suppose that I've been registered successfully.

Next in
Code: (regexroute.conf) [Select]

But somehow yate keeps returning 404 for all calls.
Here're my questions:
1) Correct me pls if I made mistakes above.
2) How do I check sip call flow? Basically how can I see it online or enable traces in conf files?
3) How do you apply new configuration? For example after I edit .conf files do I need to restart yate or put any commands? Or is everything applies on fly?
4) How do I enable full non-proxy media for all calls? I need RTP packets go directly from GW1 to GW2

That's all yet. Looking forward to your answers!

Pages: [1]